Need Some Advice? Request a Callback

Code 1042

Product & Assembly Information: Code 1042- 4DV/X280/S

4DV Plywood Box, 280kg

UN Plywood Box 4DV/X280/S, for use with non-specific inners. Approved for packing groups I, II & III. Maximum permitted weight of the inner containers and their product contents is 120kg, whilst the gross package must not exceed 280kg. Vermiculite must be used with this 4DV Plywood box.
Code 1042 Plywood Box, Polythene Bag

Assembly Sheet

To ensure the packaging can fulfil its capability, it is important to pack the box correctly and compliantly as per the assembly instructions. If packed incorrectly, you risk invalidating the UN certification and the substance being compromised during transit. It is the shippers responsibility to ensure the assembly instructions are strictly followed.

Instructional Video

How to assemble UN Plywood Box 4DV/X280/S

Assemble the box, begin by unfolding the box and ensuring all slots on the base are aligned with the corresponding locking tabs, push down the base firmly, bend each tab into locked position, tap the tab securely in place using either the tab locking tool supplied separately or set of suitable pliers and hammer. Place the supplied liner bag inside the box and add a layer of vermiculite at the bottom, to a depth of at least 55mm before placing your inners product(s) ensuring minimum spacing as shown on assembly sheet. Completely fill all remaining space with vermiculite ensuring a minimum layer of 55mm at the top of the box. Seal bag with 75mm adhesive tape. Placing the lid on top of the box and locking close, as with the base using the separately supplied tab locking tool or set of suitable pliers and hammer. Finish by adding 15mm strapping to the box as shown in the assembly sheet. Strapping is required for code 1041 and code 1042 only.

FAQs

Maximum permitted weight of the inner containers and their product contents is 120kg
You can choose your own appropriate non-specific inners, Articles can also be used (refer to relevant regulations).
This 4DV box has been tested and is approved with Vermiculite only, no other cushioning should be used in this box.
Yes, after assembling the 4DV box as per the assembly instructions or video demonstration, you must then finish by adding 15mm strapping to the box. How to do this is shown on the assembly sheet below. Strapping is required for code 1041 and code 1042 only.

Your Quote

View Full Quote 0
Call us